BannerFans.com

Friday, October 14, 2011

Mode Actuator replacing on Chevrolet Cobalt?


Mode Actuator


Removal & Installation


  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove the air temperature actuator. Refer to Blend Door Actuator, air temperature actuator, removal and installation.

    Click image to see an enlarged view
    Fig. Disconnect the mode actuator electrical connector
  3. Disconnect the mode actuator electrical connector.
  4. Remove the mode actuator assembly screws.
  5. Remove the mode actuator assembly.
To install:

NOTE
The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.

  1. Install the mode actuator assembly. Tighten the assembly screws to 19 inch lbs. (2 Nm).
  2. Install the mode actuator electrical connector.
  3. Install the air temperature actuator. Refer to Blend Door Actuator, air temperature actuator, removal and installation.
    NOTE
    Do not adjust any controls on the HVAC control assembly while the HVAC control assembly and actuators are calibrating. If interrupted improper HVAC performance will result.
  4. Start the engine and let run for one minute.


------------------

No comments:

Post a Comment