BannerFans.com

Friday, October 14, 2011

How to Bleed ABS system on 2006 Chevrolet Cobalt ?


Bleeding the ABS System


  1. Before servicing the vehicle, refer to the Precautions Section.
    WARNING
    The Auto Bleed Procedure may be terminated at any time during the process by pressing the EXIT button. No further Scan Tool prompts pertaining to the Auto Bleed procedure will be given. After exiting the bleed procedure, relieve bleed pressure and disconnect bleed equipment per manufacturers instructions. Failure to properly relieve pressure may result in spilled brake fluid causing damage to components and painted surfaces.
  2. Raise and support the vehicle.
  3. Remove all four tire and wheel assemblies.
  4. Inspect the brake system for leaks and visual damage. Repair or replace components as needed.
  5. Lower the vehicle.
  6. Inspect the battery state of charge.
  7. Install a scan tool.
  8. Turn the ignition ON, with the engine OFF.
  9. With the scan tool, establish communications with the ABS system. Select Special Functions. Select Automated Bleed from the Special Functions menu.
  10. Raise and support the vehicle.
  11. Following the directions given on the scan tool, pressure bleed the base brake system.
  12. Follow the scan tool directions until the desired brake pedal height is achieved.
  13. If the bleed procedure is aborted, a malfunction exists. Perform the following steps before resuming the bleed procedure:
    1. If a Diagnostic Trouble Code (DTC) is detected, diagnose the appropriate DTC.
    2. If the brake pedal feels spongy, perform the conventional brake bleed procedure again.
  14. When the desired pedal height is achieved, press the brake pedal to inspect for firmness.
  15. Lower the vehicle.
  16. Remove the scan tool.
  17. Install the tire and wheel assemblies.
  18. Inspect the brake fluid level.
  19. Road test the vehicle while inspecting that the pedal remains high and firm.
  20. Turn the ignition key ON, with the engine OFF. Check to see if the brake system warning lamp remains illuminated.
    WARNING
    If there is a brake malfunction exists, DO NOT allow the vehicle to be driven until it is diagnosed and repaired.

No comments:

Post a Comment